Tenergy 72V-12V Smart Charger + 2 Packs 96V 3800mAh High Power NiMH Battery for AirSoft Rifles or RC Cars
Tenergy High Capacity 9.6V 3500mAh Nickel Metal Hydride RC Battery Pack.Made with 8xSc 3800mAh high capacity and high power NiMH Batteries.Advanced NiMH battery technology, no battery memory effect.Easy operation, battery can be charged anytime without the need to fully discharge.Builtwith 14 gauds silicone wire andstandard Tamiya Connector.Specially design for Airsoft guns for power intensity and long running time.High maximum 38 Amp discharge rate for fast vehicle start and maneuvers.Longer running time and easier operation than original NiCd battery pack.6 months warranty.SpecificationsVoltage9.6VMaixmum Discharge Rate38AConnector TypeStandard Tamiya.DimensionsHeight 0.9"; Width 1.7"; Length 7.0"Weight15.5 Oz.Best Charger for charging all RC Car, RC air and Airsoft battery packs 7.2V, 8.4V, 9.6V and 12V. Universal for for any NiMH /NiCd battery packs 7.2V - 12V (6-10 Cells pack) Fast charger with current switch to select either, 0.9A and 1.8A. Deliver full charge within 1 - 2 hours.Charging Current 0.9A for battery packs with capacity from 1100mAh -2200mAh. For 2000mAhpack, charging time is 1 hour.Charging Current 1.8A for battery packs with capacity above 2000mAh. For 3000mAh pack, charging time is 1.5 hours.Smart Charger:with automatic voltage detection.Use pulse and negative pulse technology to avoid battery overheating during fast charging, optimized for battery pack's cycle life. Red LED will be on during charging. Automatically charging ending with negative delta V. Worldwide usage with 120-240V AC Safety protection fuse for over current, short circuit & reverse polarity protection. Accessories Included1 standard Tamiya Female connector and Fuse house with the smart battery charger. 1 connector adaptor from standard Male Tamiya to Mini Female. 1 set of clip adaptor with Male Tamiya connector on one end. 2 additional fusesSmart Charger SpecificationFOR 6V-12V NI-MH/NI-CD BATTERY PACK 6-10PCS BATTERYInputAC100-240VOutput6-12V 0.9or1.8AOperation InstructionConnect battery pack to output connector and plug AC power source. Make sure battery polarity is connected correctly (Red wire is positive) Charger will detect battery voltage automatically, Red LED will be on during charging When battery is fully charged, current will reduce to trickle charging at 50mA,Green LED will be on Battery will be charged at 0.9A or 1.8A constant current, Approximate Charging time is about 1.5hrs for 3000mAh battery,1hr for 1800mAh battery. The charger is designed for faster charging NiCd and NiMH battery packs from 6 to 12V for RC car/Air and Air soft gun. Don't charger battery pack with voltage less than 6V or Voltage bigger than 12V and Capacity smaller than1100mAh. Battery pack must be made by high drain current cell. Please contact your seller for instruction. Mfg is not responsible for any damage and consequent damage by Misusage. The Third Party Customer Reviews (A new window will open)