Rhodius DG210 ALLCUT 303370 Diamond cutting disc 1 pc(s)
Machine suitability: The DG210 ALLCUT diamond cutting disc is suitable for manual use as well as for stationary use: For angle grinders, petrol separators and table saws (depending on diameter). It can play its full strengths on machines of all power classes and especially on high-performance machines. Material suitability: The DG210 ALLCUT has been specifically developed for the machining of reinforcement steel and light construction steel.This Rhodius quality tool is also very well suited for machining granite, hard concrete with surcharges, marble, paving stones, clay roofing tiles, hard wall tiles, reinforced concrete and reinforced concrete, concrete and paving brick, hard stone and paving slabs, concrete pipes or curbstones, medium-hard brick, Slate, hard sand lime brick, hard concrete, block stones, concrete roofing tiles, Sandstone, hollow blocks as well as soft concrete stone. Construction and production: The DG210 ALLCUT has a segmented cutting edge. Thus a very high cutting speed with simultaneous maximum service life is achieved. The tool is tested according to EN13236 and OSA and can be used in wet cut and also in dry cut.Thanks to the high-quality industrial diamonds the DG210 ALLCUT is especially powerful. The disc is vacuum soldered Quality: The DG210 ALLCUT gives the user the best Rhodius tool in his category. Rhodius Topline products stand for the highest level of performance and quality. Dimensions: This diamond cutting disc is available in diameters from 115 mm to 500 mm.This text is machine translated.