Cleaning Fluid TPM Wash Solvent 5 L 320023
3D-basics TPM Wash Solvent is a non-flammable, low-odor solvent used for cleaning and resolving unhardened resin in Stereolithography (SLA) 3D printed parts. 3D basics TPM Wash SolventTPM Wash Solvent (tripropylene glycol monomethyl) is a non-flammable, low-odor solvent used for cleaning and resolving unhardened resin in stereolithography (SLA) 3D-printed parts. TPM has a lower evaporation rate than IPA and TPM can wash approximately three times as many parts as IPA before it needs to be replaced.TPM is not currently certified for use with Formlabs biocompatible resins.TPM is compatible with the Finish Kit, Form Wash and Form Cure of Formlabs.ApplicationAlways wear gloves when handling TPM.To remove uncured resin from SLA or DLP printed parts, fill your cleaning vessel with the quantity specified by the manufacturer. To minimize waste, it is recommended that you clean the parts in advance before inserting them into the cleaning container to extend the life of your new TPM. This can be done in a separate container with eighth dirty TPM from previous cleaning cycles or low evaporation cleaners such as DPM, TPM, or PGDA. Place the finished pressure in the cleaning vessel, clean the parts for at least 5 minutes or according to the guidelines of the material manufacturer. After the cleaning cycle, wash the TPM-coated part with water, allow the model to dry and check for sticky surface, repeat if necessary until the surface is no longer sticky. If it is still sticky, replace the TPM.This text is machine translated.